Illegal Address; Format Error; Illegal G Code; Setting Value Range Over - Mitsubishi Electric M800 Series Manual

Hide thumbs Also See for M800 Series:

Table of Contents

M800/M80/E80/C80 Series Alarm/Parameter Manual

12 Program Errors (P)

Illegal address

An address not listed in the specifications has been used.

Correct the program address.

Correct the parameter settings.

Check the specifications.

The command format in the program is not correct.

Correct the program.

The commanded G code is not in the specifications.

An illegal G code was commanded during the coordinate rotation command.

G51.2 or G50.2 was commanded when the rotary tool axis No. (the parameter "#1501polyax") was set to

G51.2 or G50.2 was commanded when the tool axis was set to the linear axis (the parameter "#1017 rot"

Check and correct the G code address in the program.

Check the parameter setting values.

The setting range for the addresses has been exceeded.

Correct the program.

Program end error

"EOR" has been read during tape and memory mode.

Enter the M02 and M30 command at the end of the program.

Enter the M99 command at the end of the subprogram.

O, N number zero

"0" has been specified for program or sequence No.

Designate program Nos. within a range from 1 to 99999999.

Designate sequence Nos. within a range from 1 to 99999999.

No spec: Add. Op block skip

"/n" has been issued while the optional block skip addition is not in the specifications.

Check the specifications.

IB-1501279-H

Show Quick Links

Table of Contents

C80 series M80 series E80 series