High-Accuracy Control Axis Parameters - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters

15.12 High-accuracy Control Axis Parameters

#2001 rapid
Set the rapid traverse feedrate for each axis.
(Note) The maximum value to be set depends on the machine specifications.
---Setting range---
1 to 1000000 (mm/min)
#2002 clamp
Set the maximum cutting feedrate for each axis.
Even if the feedrate in G01 exceeds this value, the clamp will be applied at this feedrate.
---Setting range---
1 to 1000000 (mm/min)
#2010 fwd_g
Set a feed forward gain for pre-interpolation acceleration/deceleration.
The larger the set value, the smaller the theoretical control error will be. However, if a machine vibration oc-
curs, set the smaller value.
---Setting range---
0 to 200 (%)
#2068 G0fwdg
Set a feed forward gain for G00 pre-interpolation acceleration/deceleration.
The larger the setting value, the shorter the positioning time during in-position checking.
If a machine vibration occurs, set the smaller value.
---Setting range---
0 to 200 (%)
#2096 crncsp
Set the minimum clamp speed for corner deceleration in the high-accuracy control mode. Normally set "0".
(Note) This parameter is invalid during SSS control.
---Setting range---
0 to 1000000 (mm/min)
#2109 Rapid (H-precision)
Set the rapid traverse rate for each axis in the high-accuracy control mode. "#2001 rapid" will be used when
"0" is set.
---Setting range---
0 to 1000000 (mm/min)
#2110 Clamp (H-precision)
Set the cutting feed maximum speed for each axis in the high-accuracy control mode. "#2002 clamp" will be
used when "0" is set.
---Setting range---
0 to 1000000 (mm/min)
Rapid traverse rate
Cutting feedrate for clamp function
Feed forward gain
G00 feed forward gain
Minimum corner deceleration speed
Rapid traverse rate for high-accuracy control mode
Cutting feed clamp speed for high-accuracy control
mode
289 IB-1501279-H