Mitsubishi Electric M800 Series Manual page 372

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
The H code indicates the tool length offset number, and the D code indicates the tool radius compensation
number.
When bit 18 is set to ON, the H and D codes and group 8 G modal are retained.
When bit 7 is set to ON, the H code and group 8 G modal are retained.
<Description of bits for L system>
1F 1E 1D 1C
0 0 0 0
F E D C
0 *
* *
bit 1F: (Not used)
bit 1E: (Not used)
bit 1D: (Not used)
bit 1C: (Not used)
bit 1B: (Not used)
bit 1A: (Not used)
bit 19: Spindle clamp rotation speed initialization
bit 18: (Not used)
bit 17: (Not used)
bit 16: (Not used)
bit 15: (Not used)
bit 14: (Not used)
bit 13: Group 20 2nd spindle control modal initialization
bit 12: (Not used)
bit 11: Group 18 Balance cut initialization
bit 10: Group 17 Constant surface speed control command modal initialization
bit F: Group 16 Retains inclined surface machining modal
bit E: Group 15 Facing turret mirror image initialization
bit D: (Not used)
bit C: Group 13 Cutting modal initialization
bit B: Group 12 Workpiece coordinate system modal initialization
bit A: (Not used)
bit 9: Group 10 Fixed cycle return command modal initialization
bit 8: (Not used)
bit 7: (Not used)
bit 6: Group 7 Nose R compensation modal initialization
bit 5: Group 6 Inch/metric modal initialization
bit 4: Group 5 Feed G modal initialization
bit 3: Group 4 Barrier check modal initialization
bit 2: Group 3 Absolute/incremental command modal initialization
bit 1: Group 2 Plane selection modal initialization
bit 0: Group 1 Move G modal initialization
1B 1A 19 18 17 16 15 14 13 12 11 10
0 0 * 0 0 0 0 0
*
B A 9 8 7 6 5 4 3
0 * 0 0 *
* * * *
355
0 *
*
2 1 0
* * *
IB-1501279-H