G00Drn; G0Lntp; I_G611; Hold Intr Amount - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
#1085

G00Drn

Select whether to apply dry run (feed at manual setting speed instead of command feedrate) to the G00 com-
mand.
0: Not apply to G00. (move at rapid traverse rate)
1: Apply to G00. (move at manual setting speed)
#1086

G0lntp

Select the G00 travel path type.
0: Move linearly toward the end point. (interpolation type)
1: Move to the end point of each axis at the rapid traverse feedrate for each axis. (non-interpolation)
(Note) If this parameter is set to "1", neither of the following functions will be available: rapid traverse constant
inclination acceleration/deceleration and rapid traverse constant inclination multi-step acceleration/decel-
eration.
#1148

I_G611

Select the modal state at power ON from among the following: high-accuracy control mode, high-speed high-
accuracy control I mode, high-speed high-accuracy control II mode or high-speed high-accuracy control III
mode.
0: G08P0/G64 (cutting) mode
1: G08P1/G61.1 (high-accuracy control) mode
2: G05.1Q1 (high-speed high-accuracy control I) mode
3: G05P10000 (high-speed high-accuracy control II) mode
4: G05P20000 (high-speed high-accuracy control III) mode
#8173

Hold intr amount

Select whether to clear or hold the interruption amount after the "NC reset 1 (or 2)" signal is ON when the
manual ABS switch is OFF.
0: Clear (Reset the coordinate deviation due to the interruption)
1: Hold
#8174 T meas. in mirror
Select the measurement operation for mirror-imaged axes during the manual tool length measurement 1 or 2.
0: Set the measurement result as the tool length.
1: Reverse the sign of measurement result and set it as the tool length.
IB-1501279-H
G00 dry run
G00 non-interpolation
Initial hi-precis
228