Alarm Window On; T Code Offset Disp; Selective Display - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
#8970 Tool offset type 2
Specify the display item for the 3rd column (type) and 4th column (compensation amount) on the right side
of the tool management screen list display.
The setting value and display item are specified as follows.
(Setting value): (3rd column) / (4th column)
· Tool compensation type I
0-11 : Set to blank / Set to blank
· Tool compensation type II
0,5-11 : D (Compensation No.) / Radius compensation
1 : H (Compensation No.) / Length compensation
2 : D (Compensation No.) / Radius compensation
3 : +H (Compensation No.) / Length wear
4 : +D (Compensation No.) / Radius wear
· Tool compensation type III
0 : (Axis name (2nd axis))(Compensation No.) / 2nd axis tool length
1 : (Axis name (1st axis))(Compensation No.) / 1st axis tool length
2 : (Axis name (2nd axis))(Compensation No.) / 2nd axis tool length
3 : (Axis name (Additional axis))(Compensation No.) / Additional axis tool length
4 : +(Axis name (1st axis))(Compensation No.) / 1st axis wear
5 : +(Axis name (2nd axis))(Compensation No.) / 2nd axis wear
6 : +(Axis name (Additional axis))(Compensation No.) / Additional axis wear
7 : R / Nose R
8 : +R / R wear
9 : P / Point
10 : (Axis name (2nd additional axis))(Compensation No.) / 2nd additional axis tool length
11 : +(Axis name (2nd additional axis))(Compensation No.) / 2nd additional axis wear
---Setting range---
0 to 11
#8971

Alarm window ON

Select whether to enable the alarm display window.
0: Disable
1: Enable
#8972

T code offset disp

For L system only
Select whether to display tool offset data with the address T's offset No. at the head when the tool offset
screen is opened after a manual value command.
<Monitor screen>
* Open the tool offset screen (window)
<Setup screen>
* Display the tool offset screen
(Note) The display is unchanged if you change a tool offset No. with the tool offset screen displayed.
0: Not display tool offset data with the address T's offset No. at the head
1: Display tool offset data with the address T's offset No. at the head
(PR) #8973

Selective display

Select whether to enable selective display on an 8.4- or 10.4-type display terminal.
0: Disable selective display
1: Enable selective display. Select what to display using the parameter "#8940 Set select display".
309 IB-1501279-H