Mitsubishi Electric M800 Series Manual page 652

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#4005 pdvno
Set the compensation data No. at the farthest end on the positive side.
(Note) When the axis moves in negative direction with two-way pitch error compensation enabled, set com-
pensation data No. of which locates on the nearest point to positive side. The compensation point should
be set with even number.
---Setting range---
4101 to 5124
#4006 sc
Set the scale factor for the compensation amount.
---Setting range---
0 to 99
#4007 spcdv
Set the interval to divide the basic axis.
Each compensation data will be the compensation amount for each of these intervals.
---Setting range---
0.001 to 9999.999 (mm)
#4008 twopc
Select whether to enable two-way pitch error compensation.
0: Disable
1: Enable
#4009 refcmp
When two-way pitch error compensation is enabled, set the compensation amount of the reference position
when the axis moves to the position from the opposite direction of the zero point return.
---Setting range---
-32768 to 32767
(Note) The actual compensation amount will be the value obtained by multiplying the setting value with the
compensation scale.
#4101-5999
Set the compensation amount for each axis.
---Setting range---
-32768 to 32767
(Note) The actual compensation amount will be the value obtained by multiplying the setting value with the
compensation scale.
Division point number at the most positive side <n-th
axis>
Compensation scale factor <n-th axis>
Division interval <n-th axis>
Two-way pitch error compensation <n-th axis>
Reference position compensation amount <n-th axis>
635 IB-1501279-H