Unable To Start Automatic Mode; Tool Data Sorting In Progress; Tolerance Control Invalid; Ill Manualmode Select In 3Dcnv - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
1 Operation Errors (M)
M01

Unable to start automatic mode

Details
Although start of automatic operation is not allowed after a machine groupwise alarm stop ("#1472
mgralmrestart"=0), start of automatic operation has been attempted after the said alarm stop.
The cycle operation is started with the guide bushing spindle synchronization related spindle is not being
set.
The cycle operation is started while the "G/B spindle synchronization: temporary cancel" signal is turned
ON.
Remedy
Remove the cause of the stop by alarm.
Set the parameter "#1472 mgralmrestart" (Allowing automatic operation to start after machine groupwise
alarm stop) to "1".
Check the parameter "#3074 GBsp".
Turning OFF the "G/B spindle synchronization: temporary cancel" signal before starting the cycle opera-
tion.
M01

Tool data sorting in progress

Details
Cycle start or graphic check has been attempted during sorting of tool management data.
Remedy
Execute cycle start after the tool data sorting is completed.
Execute graphic check after the tool data sorting is completed.
M01

Tolerance control invalid

Details
The parameter "#12066 Tolerance ctrl ON" is set to "1", although "#8090 SSS ON" is "0".
Remedy
To enable the tolerance control, set "#8090 SSS ON" to "1".
To disable the tolerance control, set "#12066 Tolerance ctrl ON" to "0".
M01

Ill manualmode select in 3Dcnv

Details
The following unselectable manual mode was selected during 3-dimensional coordinate conversion.
manual reference position return
Remedy
Cancel the 3-dimensional coordinate conversion modal.
M01 Start err in PRM rot manu feed
Details
Axis start has been attempted with any of the following operations while the coordinate rotation by parameter
for manual feed is enabled.
Tool retract and return
Manual tool length measurement
Manual skip
Remedy
Turn OFF the "Coordinate rotation by parameter: Coordinate switch for manual feed" signal.
M01 Multiaxes in RRM rot manu feed
Details
Two or more of the three basic axes were started at a time for the coordinate rotation by parameter for manual
feed.
Remedy
Disable the coordinate rotation by parameter for manual feed or start one axis at a time.
15
0137
0138
0139
0145
0146
0147
IB-1501279-H