We Meas. Wk Coord; We Meas. Ext Wk No; We Mea. Wk X-Width; We Mea. Wk Y-Width - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
#8718

WE meas. wk coord

[M8]
Specify the workpiece coordinate system in which you input the workpiece coordinates for workpiece instal-
lation error measurement.
Set the number part of the coordinate system modal. (54, 54.1, 55, 56, 57, 58 or 59)
---Setting range---
0, 54 to 59
#8719

WE meas. ext wk No

[M8]
If workpiece installation error measurement is performed in the extended workpiece coordinate system,
specify the address P value of G54.1.
If "#8718 WE meas. wk coord" is not 54.1, there is no need for setting this parameter.
---Setting range---
0 to 300
#8720

WE mea. wk X-width

[M8]
Specify the X direction width of the rectangular workpiece for which workpiece installation error measurement
is performed.
If the sensor's accessible range is small due to jig etc., specify the width of the portion that is stuck out of the
jig.
---Setting range---
0.000 to 99999.999 (mm)
#8721

WE mea. wk Y-width

[M8]
Specify the Y direction width of the rectangular workpiece for which workpiece installation error measurement
is performed.
If the sensor's accessible range is small due to jig etc., specify the width of the portion that is stuck out of the
jig.
---Setting range---
0.000 to 99999.999 (mm)
#8722 WE mea. wk Z-width
[M8]
Specify the Z direction width of the rectangular workpiece for which workpiece installation error measurement
is performed.
If the sensor's accessible range is small due to jig etc., specify the width of the portion that is stuck out of the
jig.
---Setting range---
0.000 to 99999.999 (mm)
#8723 WK inst. err comp#
[M8]
Specify the workpiece installation error No. for write during the workpiece installation error measurement.
Set 1 for G54.4 P1.
---Setting range---
0 to 7
211 IB-1501279-H