Wem Mcr No; Ref Sphere Dia; F-Bus 1 Err Switch; F-Bus 2 Err Switch - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#11701

WEM Mcr No

[M8]
Specify the name of macro program for the workpiece installation error measurement.
The macro program name is output at initialization of workpiece installation error measurement macro.
The macro program is used for execution of the measurement.
---Setting range---
0, 9000 to 9099, 9300 to 9999, 100010000 to 100018999, 100030000 to 199999998
#11702

Ref Sphere Dia

[M8]
Specify the diameter of reference sphere that is used for rotation center error measurement.
If the set value is significantly different from the actual diameter, the sensor may be damaged.
---Setting range---
0.000, 1.000 to 100.000 (mm)
(PR) #11708

F-bus 1 Err Switch

[M8]
Select whether to activate emergency stop or display a warning if an error occurs on the Fieldbus expansion
card mounted in the slot EXT3 (or EXT1 for M80/M800S/E80).
(Note) The parameter does not apply to a CC-Link expansion card.
0: Emergency stop
1: Warning display
(PR) #11709

F-bus 2 Err Switch

[M8]
Select whether to activate emergency stop or display a warning if an error occurs on the Fieldbus expansion
card mounted in the slot EXT4 (or EXT2 for M80/M800S/E80).
(Note) The parameter does not apply to a CC-Link expansion card.
0: Emergency stop
1: Warning display
#11716 CutEdgeAngleType
[M8]
Select the method of specifying the cutting-edge angle that is used for turning-tool shape compensation in
Compound type fixed cycle for turning machining I.
0: Tool shape method
1: Tool compensation method
(PR) #11717 astap_sysno
[M8]
Select the part system to which the analog spindle synchronous tapping cycle is applied.
When 0 is set, the part system 1 is considered to be selected.
---Setting range---
0 to 8
IB-1501279-H
Macro No. for workpiece installation error measurement
Reference sphere diameter
Fieldbus communication error switch 1
Fieldbus communication error switch 2
Turning tool shape compensation: setting method of
cutting-edge angle
Analog spindle synch tap: Part system selection
466