Mitsubishi Electric M800 Series Manual page 375

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#1518 polm
Set the spindle No. or spindle name of workpiece axis used in spindle-spindle polygon machining.
(Note 1) The 1st spindle will be selected when "0" is set.
(Note 2) There are 2 spindle designation methods: spindle No. method and spindle name method.
When the name (1 to 9) is set to the spindle name parameter(#3077 Sname) for all the spindles, the com-
mands are issued with for each spindle name, other than that, the commands are issued with the spindle
number.
---Setting range---
0 to 9
#1519 pols
Set the spindle number or spindle name of the rotary tool axis used in spindle-spindle polygon machining.
(Note 1) The 2nd spindle will be selected when "0" is set.
(Note 2) There are 2 spindle designation methods: spindle No. method and spindle name method.
When the name (1 to 9) is set to the spindle name parameter(#3077 Sname) for all the spindles, the com-
mands are issued with for each spindle name, other than that, the commands are issued with the spindle
number.
---Setting range---
0 to 9
(PR) #1520 Tchg34
Select axis to carry out the additional axis' tool compensation function.
0: 3rd axis.
1: 4th axis.
#1521 C_min
Set the minimum turning angle of the normal line control axis at the block joint during normal line control.
---Setting range---
0.000 to 360.000 (°) (Input setting increment applies)
(PR) #1522 C_axis
Set the number of the axis for normal line control.
Set a rotary axis No.
0: Normal line control disabled
1 to 16: Axis No. (number of control axes)
#1523 C_feed
Set the turning speed of the normal line control axis at the block joint during normal line control.
Set a value that does not exceed the normal line control axis' clamp speed ("#2002 clamp").
This is valid with normal line control type I.
---Setting range---
0 to 1000000 (°/min)
#1524 C_type
Select the normal line control type.
0: Normal line control type I
1: Normal line control type II
#1533 millPax
Set the linear axis name used for pole coordinate interpolation.
---Setting range---
Axis name such as X, Y or Z
IB-1501279-H
Spindle-spindle polygon Workpiece spindle No.
Spindle-spindle polygon Tool spindle No.
Additional axis tool compensation operation (for L sys-
tem only)
Minimum turning angle
Normal line control axis
Normal line control axis turning speed
Normal line control type
Pole coordinate linear axis name
358