Canon imageRUNNER ADVANCE 9070 PRO series Service Manual Digest page 750

PF-SENS3 Adj Fold Position Sensor output: PFU
Lv.1 Details To adjust the output of Fold Position Sensor on Paper Folding Unit
automatically.
Use case • When replacing the Fold Position Sensor
• When replacing the Inserter/Folder Controller PCB
Adj/set/operate method Select the item, and then press OK key.
PF-SENS4 Adj Upper Stopper Path Sensor output:PFU
Lv.1 Details To adjust the output of Upper Stopper Path Sensor on Paper Folding
Unit automatically.
Use case • When replacing the Upper Stopper Path Sensor
• When replacing the Inserter/Folder Controller PCB
Adj/set/operate method Select the item, and then press OK key.
TRM-SENS Adj of Trimmer Dust Sensr output:Booklet
Lv.1 Details To adjust the output of Saddle Dust Sensor on Saddle Unit
automatically.
Use case • When installing the Trimmer
• When replacing the Trimmer Dust Sensor
• When replacing the Saddle Controller PCB
Adj/set/operate method Select the item, and then press OK key.
IS-CON DC Controller PCB RAM clear: Inserter
Lv.1 Details To execute the RAM clear of Inserter DC Controller PCB to delete all
the adjustment contents and counter information.
Adj/set/operate method Select the item, and then press OK key.
5
5-522
SORTER> FUNCTION
OPTION
BLNK-SW
Lv.1 Details
Use case
Adj/set/operate method 1) Enter the setting value, and then press OK key.
Display/adj/set range
Default value
MD-SPRTN
Lv.1 Details
Use case
Adj/set/operate method 1) Enter the setting value, and then press OK key.
Caution
Display/adj/set range
Default value
BUFF-SW
Lv.1 Details
T-5-97
Use case
Adj/set/operate method 1) Enter the setting value, and then press OK key.
Caution
Display/adj/set range
Default value
Supplement/memo
SORTER> OPTION
Set Sddl Fin fold pstn margin: Staple
To set the margin width of fold position on Saddle Finisher.
When changing the margin width of fold position
2) Turn OFF/ON the main power switch.
0 to 1
0: Normal, 1: Wider
2
Set restriction at Finisher error:Staple
To set whether to stop the machine when an error occurs at Finisher.
When preferring to run the machine at Finisher error occurrence
2) Turn OFF/ON the main power switch.
When "1" is set, staple operation or alignment operation is not
executed. Set "0" normally.
0 to 1
0: Normal, 1: Function restriction
0
ON/OFF of buffer operation: Fin-B1
To set ON/OFF of buffer operation in the Finisher.
When misalignment occurs, set 1 to 2.
When 1 is set, buffer operation is not performed for all jobs.
Alignment performance is improved, but productivity decreases.
When 2 is set, buffer operation is not performed only for non-binding
jobs. Since buffer operation is performed for binding jobs, productivity
improves, but alignment performance decreases.
When misalignment of paper stack occurs (misalignment of 3 sheets
at the lowest part of the stack in case of the side stitch, and 3 sheets
at the middle of the stack in case of saddle stitch)
2) Turn OFF/ON the main power switch.
When the buffer operation is set to OFF, productivity decreases.
0 to 2
0: ON, 1: OFF, 2: OFF for non-binding job only
0
This setting can be also made with DIP switch of the Finisher. For
details, refer to the Service Manual for Finisher.