Canon imageRUNNER ADVANCE 9070 PRO series Service Manual Digest page 553

OPTION
■ FNC-SW
COPIER> OPTION> FNC-SW
PO-CNT ON/OFF of potential control function
Lv.1 Details To set ON/OFF of potential control function.
Use case When replacing the Potential Sensor
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution Be sure to set the value back to 1 (ON) after servicing.
Display/adj/set range 0 to 1
0: OFF, 1: ON
Default value 1
MODEL-SZ Fixed magnifictn & DADF orgnl dtct size
Lv.1 Details To set the fixed magnification ratio display and the original detection
size with DADF.
It is set automatically at the time of installation of the Reader
according to the location.
Use case Upon user's request
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/adj/set range 0 to 3
0: AB configuration (6R5E) for Japan, 1: Inch configuration (5R4E)
for North/Middle/South America, 2: A configuration (3R3E) for
Europe, 3: AB/Inch configuration (6R5E) for Asia, Oceania, South
America
Default value The default differs according to the location.
SCANSLCT ON/OFF of scan area calculate function
Lv.2 Details To set ON/OFF of the function to calculate scanning area from the
specified paper size.
When the paper size is larger than the original size, selecting ON
reduces productivity because the scanning area gets larger.
Use case When matching the scanning area with the paper size
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/adj/set range 0 to 1
0: OFF (calculated from the detected original size)
1: ON (calculated from the specified paper size)
Default value 0
COPIER> OPTION> FNC-SW
DH-SW ON/OFF of auto D-half control
Lv.2 Details To set ON/OFF of auto D-half control.
Execution interval can be set by COPIER> OPTION> IMG-FIX>
INTROT-2.
Use case • When D-half-related failure occurs/when identifying the cause of
D-half-related failure
• Upon user's request
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution Be sure to set the value back to 1 (ON) after servicing.
Display/adj/set range 0 to 1
0: OFF, 1: ON
Default value 1
Related service mode COPIER> OPTION> IMG-FIX> DH-TMG
SENS-CNF Setting of original detection size
Lv.2 Details To set original detection size according to AB configuration/Inch
configuration/A configuration.
Select 1 (Inch configuration) for Inch configuration machine or 2 (A
configuration) for A configuration machine.
Use case When replacing the Reader Controller PCB/clearing RAM data
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/adj/set range 0 to 1
0: AB configuration, 1: Inch configuration
Default value 0
5
5-325