Canon imageRUNNER ADVANCE 9070 PRO series Service Manual Digest page 451

COPIER> ADJUST> HV-TR
2TR-TGT2 Sec trns indiv set target currnt: set 2
Lv.2 Details To adjust the target current of secondary transfer for setting 2.
Setting 2 is the combination condition of environment, paper type
(paper weight), color mode and feed side that are set in TR-ENV2,
TR-PPR2, TR-CLR2 and TR-DUP2. When this condition is satisfied,
the target current that is set here is applied to the Secondary
Transfer Outer Roller.
When low-voltage mottled image or toner scattering on solid image
occurs, increase the current.
When high-voltage mottled image or density loss due to excessive
transfer occurs, decrease the current.
As the value is incremented by 1, the current changes by 2 uA.
+: Increase
-: Decrease
Use case When an image failure occurs on all paper types (mottled image,
density loss due to excessive transfer, toner scattering on solid
image, etc.)
Adj/set/operate method Enter the setting value, and then press OK key.
Caution Increase/decrease the value by 1 while checking the symptom each
time.
Display/adj/set range -10 to 10
Unit 2 uA
Default value 0
Related service mode COPIER> ADJUST> HV-TR> TR-ENV2, TR-PPR2, TR-CLR2, TR-
DUP2, 2TR-SHR2
COPIER> ADJUST> HV-TR
2TR-TGT3 Sec trns indiv set target currnt: set 3
Lv.2 Details To adjust the target current of secondary transfer for setting 3.
Setting 3 is the combination condition of environment, paper type
(paper weight), color mode and feed side that are set in TR-ENV3,
TR-PPR3, TR-CLR3 and TR-DUP3. When this condition is satisfied,
the target current that is set here is applied to the Secondary
Transfer Outer Roller.
When low-voltage mottled image or toner scattering on solid image
occurs, increase the current.
When high-voltage mottled image or density loss due to excessive
transfer occurs, decrease the current.
As the value is incremented by 1, the current changes by 2 uA.
+: Increase
-: Decrease
Use case When an image failure occurs on all paper types (mottled image,
density loss due to excessive transfer, toner scattering on solid
image, etc.)
Adj/set/operate method Enter the setting value, and then press OK key.
Caution Increase/decrease the value by 1 while checking the symptom each
time.
Display/adj/set range -10 to 10
Unit 2 uA
Default value 0
Related service mode COPIER> ADJUST> HV-TR> TR-ENV3, TR-PPR3, TR-CLR3, TR-
DUP3, 2TR-SHR3
5
5-223