Canon imageRUNNER ADVANCE 9070 PRO series Service Manual Digest page 126

E Detailed Occurance Items
code code area
E5F3 -8001 -05 Title
Description
of detection
Measures
3
3-100
Description
A. Error in the saddle alignment guide motor (Finisher-A1)
B. Aligning plate home position error (Finisher-B1)
A. The saddle alignment plate HP sensor does not detect
the saddle alignment guide when the saddle alignment
guide has been moved for 177 mm by saddle
alignment guide motor.
B. The aligning plate home position sensor does not turn
ON when the aligning plate motor has been driven for
500 pulses.
A:
A-1. The connector of the saddle alignment plate
HP sensor (S206) or the saddle alignment guide
motor (M202) are disconnected.
A-2. The wiring of the saddle alignment plate HP
sensor/the saddle alignment guide motor are
faulty.
A-3. The saddle alignment plate HP sensor is faulty.
A-4. The saddle alignment guide motor is faulty.
A-5. The saddle stitcher controller PCB is faulty.
A-6. The finisher controller PCB is faulty.
B:
B-1. The aligning plate home position sensor (PI5)
is faulty.
B-2. The aligning plate drive mechanism is faulty.
B-3. The aligning motor (M5) is faulty.
B-4. The saddle stitcher controller PCB is faulty.
E Detailed Occurance Items
code code area
E5F3 -8002 -05 Title A. Error in the saddle alignment guide motor (Finisher-A1)
B. Aligning plate home position error (Finisher-B1)
Description A. The saddle alignment guide does not come off the
of detection saddle alignment plate HP sensor when the saddle
alignment guide motor has been driven for 50 pulses.
B. The aligning plate home position sensor does not turn
OFF when the aligning plate motor has been driven for
50 pulses.
Measures A:
B:
Description
A-1. The connector of the saddle alignment plate
HP sensor (S206) or the saddle alignment guide
motor (M202) are disconnected.
A-2. The wiring of the saddle alignment plate HP
sensor/the saddle alignment guide motor are
faulty.
A-3. The saddle alignment plate HP sensor is faulty.
A-4. The saddle alignment guide motor is faulty.
A-5. The saddle stitcher controller PCB is faulty.
A-6. The finisher controller PCB is faulty.
B-1. The aligning plate home position sensor (PI5)
is faulty.
B-2. The aligning plate drive mechanism is faulty.
B-3. The aligning motor (M5) is faulty.
B-4. The saddle stitcher controller PCB is faulty.