Waste Toner Full Sensor - Canon imageRUNNER ADVANCE 9070 PRO series Service Manual Digest

■ ITB
Procedure of parts Refer to Chapter 0, "Removing the ITB."
replacement
Procedure of
Caution:
adjustment
Be sure to execute "Operation after ITB replacement" when
releasing the ITB pressure.
■ Primary Transfer Roller
Procedure of parts Refer to Chapter 0, "Removing the Primary Transfer Roller."
replacement
Procedure of 1) Execute the Primary Transfer ATVC.
adjustment (COPIER > FUNCTION > MISC-P> 1ATVC-EX)
■ Patch Sensor Unit
Procedure of parts Refer to Chapter 4, "Removing the Patch Sensor Unit."
replacement
2
Procedure of 1) Enter the Patch Sensor Alpha Value.
adjustment (COPIER > OPTION > IMG-MCON > P-ALPHA)
2) Adjust the Patch Sensor Light Intensity.
(COPIER > FUNCTION >MISC-P > PT-LPADJ)
■ Waste Toner Container
Procedure of parts Refer to Chapter 0, "Removing the Waste Toner Box."
replacement
Procedure of 1) Clear the Waste Toner Counter. (COPIER>FUNCTION>CLEAR>W-TN-CLR)
adjustment 2) Install a new Waste Toner Container.
3) Execute the offset adjustment of Waste Toner Full Sensor. (COPIER >
FUNCTION > MISC-P > WTN-OFST)

■ Waste Toner Full Sensor

Procedure of parts Refer to Chapter 6, "List of Sensor."
replacement
Procedure of 1) Install the Waste Toner Container.
adjustment 2) Execute the offset adjustment of Waste Toner Full Sensor.
(COPIER > FUNCTION > MISC-P > WTN-OFST)
■ Fixing belt Unit
Procedure of parts Refer to Chapter 4, "Removing the Fixing Belt Unit."
replacement
2-12
Procedure of 1) When replacing the Fixing Belt Unit, be sure to apply grease (Molykote
adjustment PG641) to the 3 gears of the Pressure Belt Unit.
• Application quantity: 100 mg / 1 gear
• Range: whole circumferences of gear tooth surface
T-2-28
T-2-29
T-2-30
2) Clean the Inlet Guide and Sensor Flag with lint-free paper moistened with
alcohol.
T-2-31
3) Clear the counter.
COPIER > COUNTER > DRBL-1 > FX-BLT-U
NOTE:
When the foregoing counter clear is executed, the following item is
cleared.
T-2-32
Pressure belt Unit
■
Procedure of parts Refer to Chapter 4, "Removing the Pressure Belt Unit."
replacement
3 gears
Pressure Belt Unit
COPIER > DISPLAY > FIXING > FX-U-TM1-8
COPIER > DISPLAY > FIXING > FX-U-STR
T-2-33