Canon imageRUNNER ADVANCE 9070 PRO series Service Manual Digest page 415

COPIER> ADJUST> ADJ-XY
ADJY-DF2 Adj img pstn in DADF mod:horiz scan[bck]
Lv.1 Details To adjust the image position of back side in horizontal scanning
direction at simultaneous duplex reading.
When replacing the Reader Controller PCB/clearing RAM data, enter
the value of service label.
As the value is incremented by 1, the image position moves to the
rear side by 0.1mm.
Use case When replacing the Reader Controller PCB/clearing RAM data
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the
service label.
Display/adj/set range 56 to 220
Unit 0.1 mm
Default value 124
■ CCD
W-PLT-X
Lv.1 Details
Use case
Adj/set/operate method 1) Enter the setting value, and then press OK key.
Caution
Display/adj/set range
Default value
Related service mode
W-PLT-Y
Lv.1 Details
T-5-31
Use case
Adj/set/operate method 1) Enter the setting value, and then press OK key.
Caution
Display/adj/set range
Default value
Related service mode
W-PLT-Z
Lv.1 Details
Use case
Adj/set/operate method 1) Enter the setting value, and then press OK key.
Caution
Display/adj/set range
Default value
Related service mode
COPIER> ADJUST> CCD
White level data(X) entry of white plate
When replacing the Reader Controller PCB/clearing RAM data, enter
the value of service label. When replacing the Copyboard Glass,
enter the value of barcode label which is affixed on the glass.
• When replacing the Reader Controller PCB/clearing RAM data
• When replacing the Copyboard Glass
2) Turn OFF/ON the main power switch.
Do not use this at the normal service.
1 to 9999
8271
COPIER> ADJUST> CCD> W-PLT-Y, W-PLT-Z, BW-TGT
White level data(Y) entry of white plate
When replacing the Reader Controller PCB/clearing RAM data, enter
the value of service label. When replacing the Copyboard Glass,
enter the value of barcode label which is affixed on the glass.
• When replacing the Reader Controller PCB/clearing RAM data
• When replacing the Copyboard Glass
2) Turn OFF/ON the main power switch.
After the setting value is changed, write the changed value in the
service label.
1 to 9999
8735
COPIER> ADJUST> CCD> W-PLT-X, W-PLT-Z, BW-TGT
White level data(Z) entry of white plate
When replacing the Reader Controller PCB/clearing RAM data, enter
the value of service label. When replacing the Copyboard Glass,
enter the value of barcode label which is affixed on the glass.
• When replacing the Reader Controller PCB/clearing RAM data
• When replacing the Copyboard Glass
2) Turn OFF/ON the main power switch.
After the setting value is changed, write the changed value in the
service label.
1 to 9999
9418
COPIER> ADJUST> CCD> W-PLT-X, W-PLT-Y, BW-TGT
5
5-187