Canon imageRUNNER ADVANCE 9070 PRO series Service Manual Digest page 601

COPIER> OPTION> NETWORK
DDNSINTV Set of DDNS periodical update interval
Lv.1 Details DNS registration is executed only once at start-up with the current
iR, so the registered contents are deleted in an environment where
the DNS server settings are deleted at intervals.
To set the interval of DDNS periodical update for not deleting the
registered contents.
Use case When the DNS server settings are deleted at intervals
Adj/set/operate method Enter the setting value, and then press OK key.
Display/adj/set range 0 to 48
0: No periodical update, 1: 1-hour interval, 2: 2-hour interval, ..., 47:
47-hour interval, 48: 48-hour interval
Unit 1 hour
Default value 24
■ CUSTOM
SC-L-CNT
Lv.1 Details
Use case
Adj/set/operate method 1) Enter the setting value, and then press OK key.
T-5-71
Display/adj/set range
Default value
Related service mode
SCANTYPE
Lv.1 Details
Use case
Display/adj/set range
Default value
ABK-TOOL
Lv.1 Details
Use case
Adj/set/operate method 1) Enter the setting value, and then press OK key.
Display/adj/set range
Default value
Supplement/memo
DEV-SP1
Lv.2 Details
Adj/set/operate method 1) Enter the setting value, and then press OK key.
Caution
Display/adj/set range
Unit
Default value
COPIER> OPTION> CUSTOM
Set large paper jdgmt reference at scan
To set the judgment reference of the scan counter as to which to use
B4 or LTR to determine large size.
The threshold is determined by the combination with the setting of
B4-L-CNT.
SC-L-CNT=0, B4-L-CNT=0: paper exceeding B4 is determined as
large size, paper with B4 or smaller is determined as small size.
SC-L-CNT=0, B4-L-CNT=1: paper with B4 or larger is determined as
large size, paper smaller than B4 is determined as small size.
As needed
2) Turn OFF/ON the main power switch.
0 to 1
0: B4 size, 1: LTR size
0
COPIER> OPTION> USER> B4-L-CNT
Switch of ADF + Reader
To switch to a different type ADF + Reader Unit.
At installation
0 to 1
0: Reverse Duplex ADF + Reader, 1: 1-Path Duplex ADF + Reader
0
Allow access from address book mntc tool
To set whether to accept import from the address book maintenance
tool.
When executing import from the address book maintenance tool
2) Turn OFF/ON the main power switch.
0 to 1
0: Disabled, 1: Enabled
0
Address book maintenance tool: Tool provided from CMJ.
Device special settings 1
To execute the device special settings.
2) Turn OFF/ON the main power switch.
Change the setting value in accordance with the instructions from
the Quality Support Division.
00000000 to 11111111
bit
00000000
5
5-373