Canon imageRUNNER ADVANCE 9070 PRO series Service Manual Digest page 25

Procedure of 1) When replacing the Pressure Belt Unit, be sure to apply grease (Molykote
adjustment PG641) to the 3 gears of the Fixing Belt Unit.
• Application quantity: 100 mg / 1 gear
• Range: whole circumferences of gear tooth surface
3 gears
Fixing Belt Unit
T-2-34
Procedure of 2) Clean the oil on the contact wheel of the Pressure Belt Position Sensor and
adjustment the oil spilled from the Pressure Belt with lint-free paper.
Pressure Sub Thermistor2
3) Clean the Inlet Guide and Sensor Flag with lint-free paper moistened with
alcohol.
4) Clear the counter.
COPIER > COUNTER > DRBL-1 > FX-BLT-L
NOTE:
When the foregoing counter clear is executed, the following item is
cleared.
COPIER > DISPLAY > FIXING > FX-U-TM1-8
COPIER > DISPLAY > FIXING > FX-U-STR 2-8
Fixing assembly
■
Procedure of parts Refer to Chapter 4, "Removing the Fixing Unit."
replacement
Contact Wheel
2
T-2-35
2-13