Mitsubishi Electric MELDAS 600M Series Instruction Manual page 80

(3) Notes for machining time calculation operation
1)
2)
3)
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
2. Monitor (Operation) Screens
If the NC operation status is as shown below when starting the machining time calculation, an
alarm occurs.
NC operation status at time
calculation operation start
In automatic operation
In graphic check
In restart search
During the machining time calculation (while the "Calculating machin time" message is
displayed), setting display unit key operations are not accepted except on the
menu and
Calcul cancel
The time calculation can be stopped by pressing the
In the following cases, the system will standby for the
the calculation of the machining time.
• When a program error occurs while calculating the time, and the system stops.
• When the block corresponding to the designated end position stops due to an error that the
block does not exist in the program.
To cancel the machining time calculation, press
(Note) The machining time calculation process is canceled if the screen is changed during
calculation of the machining time.
search engine
Alarm display
Program running
Checking
Executing restart search
menu. Thus, screen operations are not possible.
Calcul cancel
I – 65
menu key.
Calcul cancel
menu key operation during
Calcul cancel
instead of NC Reset.
Time calcul