Mitsubishi Electric MELDAS 600M Series Instruction Manual page 180

Number
35 0112
35 0113
35 0114
35 0115
35 0116
35 0118
35 0119
35 0120
35 0121
35 0122
35 0123
35 0124
35 0125
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
Name
Dev 1 This is set when starting the output device with a DC
DC2/DC4 code while transmitting data from the NC memory to
output the output device.
It is set matching the specifications of the output
device.
Dev 1 During output with the ISO code, this is set when
CR output inserting a <CR> code immediately before the EOB
(L/F) code.
Dev 1 During data output, this sets output by either the ISO
EIA output code or EIA code.
The ISO/EIA are automatically judged during data
input.
Dev 1 During data input into the NC memory, this is set
parity V when checking the parity V in one block.
Dev 1 During data transfer, this sets the timeout time that
timeout time detects the interruption of the data transfer.
An error occurs when the reading of one block or
output time of 250 characters exceeds the
designated time (timeout time), due to an I/O device
fault or an exchange in the transmission.
The timeout time setting must be changed
depending on the baud rate.
Dev 1 An alternate code can be designated for the codes at
EIA code 1 [ left that exist in the ISO but not in the EIA.
Dev 1
Designate codes (odd-numbered codes) that do not
EIA code 2 ]
duplicate preexisting EIA codes, and will not become
parity H.
Dev 1
EIA code 3 #
(Note) Do not designate the following codes:
Dev 1
0 to 9, A to Z, +, –, · , ', EOR, EOB, (,),
EIA code 4 ∗
BS, TAB, SP, &, DEL, DC1 to DC4
Dev 1
EIA code 5 =
Dev 1
EIA code 6 :
Dev 1 This sets the type of printer to output to.
printer type
(Valid for device name PTR.)
Dev 1 This designates the length of the paper tape feed
feed number section (feed holes only) output before and after the
data when outputting the tape. The length is set as a
number of characters.
The feed length is the same for both before and after
the data.
search engine
3. Setup Screens
Details
I – 165
Setting range (units)
0 : DC2 invalid
DC4 invalid
1 : DC2 valid
DC4 invalid
2 : DC2 invalid
DC4 valid
3 : DC2 valid
DC4 valid
0 : Invalid
1 : Valid
0 : ISO output
1 : EIA output
0 : Invalid
1 : Valid
0 to 999 (1/10s)
0 to FF
0 : Other than device
name PTR
1 : Mitsubishi printer
2 : EPSON (ESC/P)
0 to 999 (characters)