Mitsubishi Electric MELDAS 600M Series Instruction Manual page 444

1.2 Inputting/outputting Fixed cycle programs
Fixed cycle programs are transferred (input/output with an external device) on the input/output
(IN/OUT) screen. Check that the parameter "110007 Fix_P" for Fixed cycle operation on the basic
specification parameter screen has been set to "1".
The operation method is the same as for transferring user machining programs.
(1) Inputting (External device → Memory)
The operation method is the same as for user machining programs.
Generally, a group of 12 Fixed cycle subprograms constitutes a set and, therefore, greater
convenience is afforded if programs are prepared in such a way that the data can be input
continuously.
When the data transfer begins, the message "Transferring" appears. When the EOR code is read,
the data transfer stops and the message "Transfer complete" appears.
After program entry, it should be checked that the programs have been entered correctly on the
program file and editing pages.
(2) Outputting (Memory → External device)
The operation method is the same as for user machining programs.
There are two ways of outputting the Fixed cycle programs which have been entered: output of
one program at a time or output of all programs together.
When the data transfer begins, the message "Transferring" appears. When the EOR code is read,
the data transfer stops and the message "Transfer complete" appears.
After programs have been output, they must be checked that there are no data output errors.
(3) Erasing
The operation method is the same as for user machining programs.
There are two ways of erasing registered Fixed cycle programs: Erasing one program at a time or
erasing batches of several continuous programs.
Designate the device, directory and No. of the program to be erased in the setting column A.
When erasing a batch of several continuous programs, designate the range of Nos. to be erased.
If the data erasing process completes correctly, the message "Erase complete" is displayed.
If some files remain that could not be erased when erasing several programs, the message "Erase
ended. Some file not erased" is displayed.
Downloaded from ManualsNet.com
CHAPTER 4 APPENDICES
Appendix 1. Fixed cycle Programs
search engine
IV – 2