Mitsubishi Electric MELDAS 600M Series Instruction Manual page 45

2.1.1 Changing the counter display
(1) Counter type menus
When the menu key
of the counter display can be selected from the following types.
(Note 1)
(Note 2)
(Note 3)
(2) Operation methods (To display the current position in the counter display.)
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
Counter type
Menu
This displays the currently executed position and the status symbol when
the position is at a specified position or status.
Currnt
#1 to #4 : 1st to 4th reference point position
posn
] [ : Servo OFF state
MR : Mirror image
> < : Axis removal state
This displays the G54 to G59 workpiece coordinate system modal No.
Work
and the workpiece coordinate position in that workpiece coordinate
co posn
system.
This displays the coordinate value of each axis in the basic machine
Mach
coordinate system having a characteristic position, specified by the
posn
machine, as a zero point.
This displays the value obtained by subtracting the tool offset amount
offset for that axis from the position actually being executed for each
Prog
posn
axis.
[Program position] = [Current position] – Tool offset amount
This displays the remaining distance of the movement command being
Remain executed during automatic start or automatic halt. (The remaining
cmd
distance is the incremental distance from the current position to the end
point of that block.)
This displays the amount moved with the manual mode while the manual
absolute switch was OFF.
Man
int amt
If the control parameter "Interrupt amt reset" is ON, the interrupt amount
is cleared when the reset button is pressed.
This displays the command contents of the block executed after the
Next
cmd
block currently in execution during automatic operation.
This displays the position of the program zero point.
Prog
0-pnt
This displays the error compensation amount.
Err
compen
If the key is pressed while the submenu is displayed, the main menu appears.
Changeover of the counter type can be prohibited by setting the basic common parameter
"Counter selct invld" to 1.
If the counter type is changed, the selected counter type will be held. When the power is
turned ON, the previously displayed counter will be displayed.
1)
Press the menu key
.
Counter type
2)
Press the menu key
.
Currnt posn
search engine
2. Monitor (Operation) Screens
is pressed, the following submenu appears. The display contents
Details
The following menu appears.
Currnt Wk co
posn posn
The current position counter appears in the counter
display area.
I – 30
Mach Prog Remain Man
posn posn cmd int amt
Type
C
C
C
C
C
C
C
C
C
• • •