Machining time
calculating error
Setting error
FLD not ready
Can't input data
Can't command manual
value
2.4 Graphic display-related operation messages
Program check
completed
Checking
Check stopped
Executing trace
Data range error
Reset complete
Push [Check reset]
menu
Memory over
Downloaded from
ManualsNet.com
Appendix 2. Operation Messages
Message
• The machining time calculation process failed.
• Restart search, top search or machining time calculation was
attempted without setting the program No.
→ Always set the program No. before starting restart search, top
search or machining time calculation.
• The directory name designated for the list retrieval exceeded the
display range.
→ A directory path for which the entire directory cannot be displayed
cannot be designated in the directory name area.
• FLD restart search, top search or machining time calculation was
attempted when an FLD was not inserted.
→ Insert an FLD before starting restart search, top search or
machining time calculation.
• The FLD list display was attempted when an FLD was not inserted.
→ Insert an FLD and press the [From list] menu again.
• Data input was attempted when M, S, T, B history was displayed.
→ Input the data after closing the M, S, T, B history display.
• The manual value command process failed.
Message
• The trace in the program check completed with an M02/M30 code.
• The program check is being executed.
• When the [Check step] menu key is pressed, one step of the check is
executed, and the operation goes into standby in a check stopped
state.
• The trace mode of the graphic display is valid.
• The input data exceeded the range.
• The program check was reset.
• An error occurred in the graphic check.
→ Press the [Check reset] menu key to reset the error.
• This error occurs when outputting the accuracy measurement tool's
reference shape data.
search engine
CHAPTER 4 APPENDICES
IV – 10
Details
Details