Mitsubishi Electric MELDAS 600M Series Instruction Manual page 123

#
320031
320032
320033 Tcomp interf
320035
320036
320037 1-digit
320039
320043
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
2. Monitor (Operation) Screens
Item Setting
Coord rot ON
param invd
OFF
G04P decim pt ON
valid
OFF
ON
chk OFF
OFF
Dry run in thred ON
cut
OFF
Host link ON
OFF
ON
F feed valid
OFF
OFS Diameter ON
DESIGN
OFF
Prec ctrl dec ON
chk2
OFF
search engine
Coordinate rotation by the parameters is invalid.
Coordinate rotation by the parameters is valid.
The decimal point command of G04 address P is valid.
The decimal point command of G04 address P is invalid.
Interference check is not carried out during radius
compensation. Turn this on when carrying out radius
compensation with a fine segment program. This is the
performance condition for the high-speed machining mode IB.
Interference check is carried out during radius compensation.
When OFF, the performance is halved even in the high-speed
machining mode IB.
Dry run is executed during thread cutting.
Dry run is not executed during thread cutting. This parameter is
normally set to OFF.
The on-line state with the host computer is established.
The off-line state with the host computer is established.
F1-digit feed control becomes valid. When an F1 to F9
command is issued, the machine runs at the speed set in the
machining parameters "F1" to "F9". When an "F10" or higher
command is issued, the feedrate will be directly commanded.
This parameter cannot be selected when F1-digit feed
specifications are not supported.
The feedrate is directly commanded in all cases without
referring to the F1-digit feedrate parameter.
The compensation amount for radius compensation is input as
a diameter value.
The compensation amount for radius compensation is input as
a radius value.
If the positioning command (G0) and cutting feed command
(G1) movement directions do not change, the deceleration
check is not carried out at the joints of the positioning
command (G0) and cutting feed command (G1) blocks.
Deceleration check is carried out at the joints of the positioning
command (G0) and cutting feed command (G1) blocks.
I – 108
Details