Mitsubishi Electric MELDAS 600M Series Instruction Manual page 454

Can't read file for dev B
Can't write file for dev B
Can't seek file for dev A
Can't seek file for dev B
File name not
designated for dev A
File name not
designated for dev B
Can't open directory for
dev A
Can't open directory for
dev B
Different devices
designated in A and B
Password is illegal
Can't erase designated
file
Can't rename
designated file
Can't make directory
Can't make directory on
this device
Can't condense
designated file
Designated file is
locked
The file already exists
Program No. not found
in the file
Overwrite this file?
(Y/N)
Compare error.
Compare next file?(Y/N)
Memory over
Edit block B
Downloaded from ManualsNet.com
Appendix 2. Operation Messages
Message
• Could not read in the file for device B.
→ Recheck the connection status for device B or the input/output
parameter setting.
• Could not write in the file for device B.
→ Recheck the connection status for device B or the input parameter
setting.
→ Contact the nearest service center.
→ Contact the nearest service center.
• A file name was not designated for device A.
• A file name was not designated for device B.
• Could not find a directory corresponding to device A.
• Could not find a directory corresponding to device B.
• The same device must be designated for devices A and B, but differing
devices were designated.
• The designated password is illegal.
• Erasing was attempted of a file that cannot be erased.
• The name of a file that cannot be renamed was changed.
• An error occurred while creating the directory.
• Creation of a directory was attempted for a device that cannot have a
directory.
• Condensing of a file that cannot be condensed was attempted.
• Changing was attempted of a locked file.
• The input file name already exists.
• The file name after renaming already exists.
• Could not find a program No. description in the selected file.
• Message to confirm the operation.
[Y] or [INPUT] : Overwrite the file.
[N]
• Message to confirm the operation.
[Y] or [INPUT] : Compare the next file.
[N]
• The program cannot be written, because the memory capacity will be
exceeded. (Occurs when copying a program during tape input.)
• Execution was attempted of an operation (edit, play back, input/output,
etc.) that is prohibited for machining program B (8000 to 8999:
standard user subprogram).
search engine
CHAPTER 4 APPENDICES
: Do not overwrite the file.
: Do not compare the next file.
IV – 12
Details