Mitsubishi Electric MELDAS 600M Series Instruction Manual page 57

Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
Menu Display details
Run-out
time
Posn
display
search engine
2. Monitor (Operation) Screens
I – 42
Details
This displays the total incremented time
in each NC operation state. Refer to
"2.3.2 Setting the incremental time" for
details on setting each data.
Date : Current date
Time : Current time
Power ON : Total time from NC power
ON to OFF
Auto oper:
Total incremented time of each
machining time in memory mode
from when automatic start button is
pressed to M02/M30 or to when
reset button is pressed.
Auto Strt:
Total incremented time of automatic
start in memory mode from when
automatic start button is pressed to
feed hold stop, block stop or to when
reset button is pressed.
Ext time:
This differs depending on the user
PLC. Refer to the instruction manual
issued by the machine
manufacturer.
Upper line:
This displays the currently executed
program No., sequence No. and block
No.
Middle line:
This displays the counter and manual
value command.
The details displayed in the counter
1 and 2 can be selected from the
menu and
Counter1 type
submenus.
Counter2 type
Refer to "2.1.1 Changing the counter
display" for details.
The command values for S, M, T
and B are displayed.
Lower line:
This displays the program currently
being executed in the buffer. Note
that the buffer must be revised on
the Position display1 or 2 screen.