Mitsubishi Electric MELDAS 600M Series Instruction Manual page 463

2.15 Messages related to machine (MTB) net
(1) Messages related to all MTB net screens
(None)
(2) Messages related to transmission of diagnosis information
Transmit diagnosis
data? (Y/N)
Dialing
Waiting for the reply
Connecting
Transmitting∗∗∗
(None)
Waiting for dialing
(Status of
communication with
NC service)
(Status of
communication with
machine
manufacturer)
Downloaded from ManualsNet.com
Appendix 2. Operation Messages
Message Display in message field
Press the Send menu to transmit
the diagnosis data to the machine
manufacturer. Do not turn the power
OFF during transmission.
Message Display in message field
Press "Y" to transmit the diagnosis
data, and "N" to cancel the process.
When the line is busy, the
connection will be established after
the line becomes idle.
Do not turn the power OFF until
transmission of the diagnosis data is
completed.
Do not turn the power OFF until
transmission of the diagnosis data is
completed.
Do not turn the power OFF until
transmission of the diagnosis data is
completed.
Do not turn the power OFF until
transmission of the diagnosis data is
completed.
Press the Send menu to transmit
the diagnosis data to the machine
manufacturer. Do not turn the power
OFF during transmission.
Do not turn the power OFF until
transmission of the diagnosis data is
completed.
Connecting with NC service.
Wait for communication to end.
Connecting with machine
manufacturer.
Wait for communication to end.
search engine
CHAPTER 4 APPENDICES
IV – 21
Details
• Communication is not established.
Details
• The system is not connected with
the machine manufacturer.
• The system is checking whether
to actually send the diagnosis data
to the machine manufacturer.
• The diagnosis data is being
transmitted.
• The line is not connected yet in
this state.
• The line has been disconnected
once, and the system is waiting for
a connection from the machine
manufacturer.
• A connection with the machine
manufacturer is established, or
the system is connected to the
machine manufacturer.
• The diagnosis data is actually
being transmitted.
• Transmission of the diagnosis
data has completed, and the line
has been disconnected.
• The machine manufacturer is
using the line for other
communication.
• In connection standby state since
line is being used by anshin-net.
• In connection standby state since
line is being used by machine
manufacturer.