Mitsubishi Electric MELDAS 600M Series Instruction Manual page 77

Operation example 1
(Calculating the machining time from midway in the program to the end of the same program.)
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
2. Monitor (Operation) Screens
1)
Designate the start position.
Top search to position for
starting machining time
calculation.
• Machining program
device, directory
• Program No., sequence
No., block No.
(Note 1) Refer to "2.5.2 Executing top search" for details on how to execute top search.
(Note 2) Always set the program No.
2)
Reset the device, directory
and program Nos. designated
in step 1).
(Note 1) If the end position is designated as a random position instead of the program end,
set the end position sequence No. and block No. here.
(Note 2) Always set the program No.
(Note 3) If the program differs from the start and end of the machining calculation, refer to
"Operation example 2".
3)
Press .
Time calcul
search engine
The selected device name, directory path and program
No., etc., appear in the setting column.
When the search is completed, the message "Top
search completed" appears.
The set numbers appear in the setting column.
The machining time calculation starts. When the
machining time is calculated, a message appears.
The calculation results appear in "Mach time" on the
screen.
The setting column contents are cleared.
Press the menu key
Calcul cancel
calculation process.
I – 62
to cancel the