Mitsubishi Electric MELDAS 600M Series Instruction Manual page 221

3.10.2 Changing the spindle/standby tool No.
(1) Changing the spindle/standby tool No.
(2) Erasing the spindle/standby tool No.
3.10.3 Setting the PLC command
(1) Setting command
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
1)
Press the menu key
.
Spindle standby
2)
Set the value in the item to be
changed, and press the
INPUT key.
1)
Press the menu key
.
Spindle standby
2)
Set "0" in the item to be
erased, and press the
key.
INPUT
1)
Set the value after the menu.
12
PLC command
(Note) If the menu
PLC command
highlight returns to normal and the setting is invalidated.
2)
Press the menu
, or the
PLC command
key again to finish setting.
search engine
3. Setup Screens
The cursor appears at the tool No. of "Spnd/standby".
The spindle/standby data is changed.
The cursor appears at the tool No. of "Spnd/standby".
The spindle/standby data is invalidated.
The set value appears in the PLC command setting
column, and the PLC command is validated.
INPUT
The command details differ with the machine
manufacturer.
P LC com m and
is pressed again before the
The PLC command setting mode is released, and the
menu highlight returns to normal.
I – 206
1 2
key, the menu
INPUT