Mitsubishi Electric MELDAS 600M Series Instruction Manual page 51

(3) Operation method
During a single block stop or when a program error stop occurs, the buffer can be corrected with the
following operations, and operation can be continued.
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
2. Monitor (Operation) Screens
1)
Press the menu
.
Buffer correct
The normally executed program appears in the buffer correction area.
N121 G28 X10.Y10.;
N122 T1212;
N123 S1230 M3;
N124 G00 X68. Z201.;
N125 G01 X80. Z195. F50;
N126 Z150.;
N127 G02 X100. Z185. R20;
During buffer correction, the display changes so that the next command is at the head of the
area. The buffer correction area becomes the valid area, and the keys can be input or the cursor
moved.
The cursor can be moved freely within the buffer correction area using the cursor keys.
N121 G28 X10.Y10.;
N122 T1212;
N123 S1230 M3;
N124 G00 X68. Z201.;
N125 G01 X80. Z195. F50;
N126 Z150.;
N127 G02 X100. Z185. R20;
2)
Correct the program with the
same method as editing a
normal program.
3)
Press the key.
INPUT
4)
Confirm that the corrected
data is correct, and then
restart.
search engine
The buffer correction mode is entered.
← Previous command
← Command in execution
← Next command and subsequent commands
← Next command and subsequent commands
The buffer correction mode is entered.
The buffer correction mode ends, and the corrected
data is written into to program.
If a program error has occurred, the error display
disappears.
The program execution resumes from the currently
stopped position.
I – 36