Tool Measurement Screen - Mitsubishi Electric MELDAS 600M Series Instruction Manual

3.9 Tool Measurement screen

The tool length is measured on this screen and set as tool offset data.
Tool length measurement I
When the tool is at the reference point, the distance from the tool tip to the measurement point
(workpiece upper end) is measured, and can be set as tool offset data.
Reference point
Tool length measurement II
When the tool is at the reference point, the distance from the reference point to the tool tip is
measured, and can be set as tool offset data.
Reference point
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
Movement amount
(Tool offset data)
Workpiece
Table
Tool offset data
(internal computing)
Movement amount
Reference surface
Gauge block
height
Table
search engine
3. Setup Screens
Using a reference point return, etc., position the
tool at the reference point.
Select the measurement tool.
Turn ON the TLM switch of the machine
operation board.
Using JOG feed, manual handle feed, etc.,
move
When the measurement is completed, designate
the tool offset No.
Confirm the value of the operation parameter
"tlml".
When using the gauge block, etc., set the value
of the reference height.
Using a reference point return, etc., position the
tool at the reference point.
Select the measurement tool.
Turn ON the TLM switch of the machine
operation board.
Using JOG feed, manual handle feed, etc.,
move the tool to the measurement point.
When the measurement is completed,
designate the tool offset No.
I – 198
Start
Finish
Start
Finish