Table of Contents
Advertisement
3.5.6 Ethernet Parameter screen (Ethernet param screen)
The necessary parameters are set when carrying out Ethernet operations. Parameters with an " " added
are validated after restarting.
If the parameter length exceeds 12 characters, the data will be echo-backed into the data setting area.
Parameters 360001 to 360006
Parameters 360101 to 360413
Number
36 0001
36 0002
36 0003
36 0004
36 0005
36 0006
Downloaded from
ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
: These parameters are necessary for a network connection. When
: The server information necessary for using the Ethernet function is
Name
Address
This sets the internet address.
This sets the IP address of the TCP/IP assigned to
the NC (Windows) computer. Contact the network
controller for the address to be set.
Gateway
This sets the gateway of the TCP/IP assigned to the
NC (Windows) computer.
Connection
This is not used currently.
Timeout
This sets the timeout time (s) for when the
communication is not completed correctly, or when
there is no communication response.
Host No.
This selects the number of the host to be used from
host 1 to host 4.
Sub net
This sets the subnet mask of the TCP/IP assigned to
mask
the NC (Windows) computer. Contact the network
controller for the subnet mask to be set.
search engine
3. Setup Screens
connecting to a network, always set these parameters regardless of
whether the Ethernet function is being used. Windows must be
restarted to validate the set details. If multiple TCP/IP drivers are
installed, the same setting is made for all drivers.
set.
Server information for up to four units can be set. The set details are
validated immediately after setting.
Details
I – 168
Setting range (units)
15 characters or less
Dot notation numeric
value train
15 characters or less
Dot notation numeric
value train
0
10 to 99 (s)
(Standard: 30)
1 to 4 : Host No.
Within 15 characters
Dot notation numeric
value train
(User setting)
Advertisement
Table of Contents
