Mitsubishi Electric MELDAS 600M Series Instruction Manual page 342

4.3 Rapid traverse feed mode
The rapid traverse feed mode enables the machine to be moved consecutively at rapid traverse
feedrate manually.
The rapid traverse feedrate can be changed in four steps by using the RAPID TRAVERSE
OVERRIDE switch. The rapid traverse feed mode is started by using the FEED AXIS SELECT
switch.
(Note 1) Refer to the manual issued by the machine manufacturer for the rapid traverse feedrate.
(Note 2) See Section 5.1 for the RAPID TRAVERSE OVERRIDE switch.
Operation procedure
Using the MODE SELECT switch, select
the rapid traverse feed mode.
Using the RAPID TRAVERSE
OVERRIDE switch, set any desired
override value.
To move the controlled axis, turn ON the
FEED AXIS SELECT switch. The
controlled axis is moved while the switch
is turned ON.
When the switch is turned OFF, the
controlled axis stops with deceleration.
(Note 1) The override value set by using the CUTTING FEED OVERRIDE switch is not effective for
Downloaded from ManualsNet.com
CHAPTER 2 MACHINE OPERATIONS
the rapid traverse feedrate; when the override value is 0%, the controlled axis does not
move.
search engine
4. Operation Mode
MDI
HANDLE
INCRE-
MENTAL
FEED AXIS SELECT
+X
-X
II – 9
MODE SELECT
PROGRAM RUN
RAPID
TRAVERSE
JOG
REFERENCE
POINT
RETURN
FEED RATE
OVERRIDE
100
50
25
1
%
+4
+Z
+Y
-Y -Z -4