Mitsubishi Electric MELDAS 600M Series Instruction Manual page 455

Edit block C
Over run error
Parity H error
Framing error
I/O not ready
I/O parameter error
I/O port busy
Time out error
Parity V error
Memory alloc error
Variable conversion
error
Make directory
complete
Directory pass is illegal
The file name is a
directory
The directory is not
empty
FLD write protect
FLD not ready
File entry over
Downloaded from ManualsNet.com
Appendix 2. Operation Messages
Message
• Execution was attempted of an operation (edit, play back, input/output,
etc.) that is prohibited for machining program C (9000 to 9999:
machine manufacturer custom program).
• The buffer overran or overflowed.
• A parity H error was detected.
• An error occurred between the NC and the external device.
• An error occurred between the NC and the external device.
• The external device settings and input/output parameters do not match.
• Input/output was not possible as the I/O port is busy.
• Communication with the external device ended as a timeout.
• A parity V error was detected.
• Securing of the communication data range failed.
• An error occurred during the M2 macro conversion, and the conversion
failed.
• Creation of the directory has been completed.
• The designated directory path name is illegal.
→ Input a correct directory path name.
• A directory was designated for the file transfer. A directory cannot be
transferred.
• A file was found in the directory.
→ Erase the file in the directory.
• The FLD is write-protected.
→ Release the write protection.
• An FLD is not mounted.
→ Mount an FLD.
• The No. of registration files designated in the specifications was
exceeded, so the file could not be registered.
search engine
CHAPTER 4 APPENDICES
IV – 13
Details