Mitsubishi Electric MELDAS 600M Series Instruction Manual page 121

#
320008
320009
320010 G0 interpolation
320011 Precision thrd
320012 Radius compen
320013 Ext
320014 Initial absolute
320015 Initial synchr
320016
320017 Initial Z-X plane
320018 Initial Y-Z plane
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
2. Monitor (Operation) Screens
Item Setting
Macro interupt ON
valid
OFF
Sub-prog ON
interrupt
OFF
ON
OFF
OFF
ON
cut E
OFF
ON
type B
OFF
ON
deceleration
OFF
OFF
ON
val
OFF
ON
feed
OFF
Init cnst prphl ON
spd
OFF
ON
OFF
ON
OFF
search engine
The user macro interrupt is validated.
The user macro interrupt is invalidated.
Subprogram type user macro interrupt is applied.
Macro type user macro interrupt is applied.
When positioning in the G00 mode, each axis independently
moves at the respective rapid traverse rate. The path is not
linear in respect to the end point.
When positioning in the G00 mode, the axis moves at the
shortest distance linearly in respect to the end point.
When cutting an inch thread, address E designates the
precision lead.
When cutting an inch thread, address E designates the number
of threads per inch.
When radius compensation or executing start up or a cancel
command during radius compensation, the intersecting point of
the command block and next command block is operated.
When radius compensation or executing start up or a cancel
command during radius compensation, the start up or cancel
command block are not targets for the intersecting point
operation. The offset vector in the command right angle
direction is applied.
Even if the machine interface signal's external deceleration
signal is input, it is ignored. (The machine's rapid traverse rate
is not decelerated.)
When the external deceleration signal is input, the machine's
feedrate decelerates to the speed set with the machine
parameters.
The absolute value command mode is the initial state when the
power is turned ON.
The incremental value command mode is the initial state when
the power is turned ON.
The synchronous feed mode is the initial state when the power
is turned ON.
The asynchronous feed mode is the initial state when the
power is turned ON.
(Not used.)
(Not used.)
G18 (plane selection ZX mode) is the initial state when the
power is turned ON.
G17 (plane selection XY mode) or G19 (plane selection YZ
mode) is the initial state when the power is turned ON.
G19 (plane selection YZ mode) is the initial state when the
power is turned ON.
G17 (plane selection XY mode) or G18 (plane selection ZX
mode) is the initial state when the power is turned ON.
I – 106
Details