Mitsubishi Electric MELDAS 600M Series Instruction Manual page 451

Appendix 2. Operation Messages
The following messages appear on each screen.
2.1 Position display-related operation messages
Can't write into file
Origin set not possible
2.2 Operation search-related operation messages
Searching
Search completed
Verifying
Verifying stopped
Executing automatic
operation
Search error
Verify error
Input some of ONB
Can't cancel verify stop
2.3 Restart search-related operation messages
Executing restart
search
Restart search is
completed
Executing top search
Top search completed
Search error
Calculating machining
time
Calculating machining
time completed
Can't input data
Calculating machining
time canceled
Downloaded from ManualsNet.com
Appendix 2. Operation Messages
Message
• Could not write the data to the memory with the buffer correction.
→ Contact the nearest service center.
• The operation is in a state in which origin set is not possible.
→ Check the Data protection key 1 or the parameter "Origin zero
invalid" setting.
Message
• The operation search is being executed correctly.
• The operation search completed correctly.
• The data is being compared correctly.
• The data comparison completed correctly.
• An operation such as parameter setting or editing that cannot be
carried out during automatic operation was attempted. (Input/output is
also possible during automatic operation.)
• Could not find the designated file.
• Could not find the designated program No., sequence No. or block at
the compare stop.
• The search is not possible because one of O, N or B is not designated.
• The compare stop cannot be canceled because the operation is not in
a compare stop.
Message
• The restart search is being executed correctly.
• The restart search completed correctly.
• The top search is being executed correctly.
• The top search completed correctly.
• The restart search or top search process failed.
→ Reconsider the program.
• The machining time is being calculated correctly.
• The machining time calculation completed correctly.
• Data input was attempted during M, S, T, B history display.
• The machining time calculation was canceled correctly.
• The machining time calculation was canceled because the screen was
changed to another screen during the process.
search engine
CHAPTER 4 APPENDICES
IV – 9
Details
Details
Details