Merging A File - Mitsubishi Electric MELDAS 600M Series Instruction Manual

3.3.7 Merging a file

This section explains the method for adding the file in file setting column B to the file in file setting column
A.
Refer to section "3.3.1 Selecting a device, directory and file" for the method of designating a device,
directory and file.
The various conditions such as the port No. and the device No., etc. at merging, are set on the "I/O
param" screen.
(1) Merging a file
(Note 1) If the merge destination file (file in file setting column A) is running, an error will occur, and the
(Note 2) The devices that can be merged are the memory, HD, IC card and FLD.
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
1)
Press the menu Area change ,
and select the file setting
column A.
2)
Designate the merge
destination device, directory
and file name.
3)
Press the menu Area change ,
and select the file setting
column B.
4)
Designate the merge origin
device, directory and file name.
5)
Press the menu Merge B ->A .
6)
Press Y or INPUT .
files will not be merged.
search engine
3. Setup Screens
The designated file name appears.
The designated file name appears.
A message confirming the merge appears.
The file merge starts. The data being merged will
appear in the Input Data display column.
A message appears when the merge is completed.
The details of the file in file setting column A will be as
follows when the merge is completed.
(FILE A)
G28 XYZ;
G90 F800;
G00 X100. Y100.;
(FILE B)
G91 G28 XYZ;
F1000;
G01 X200. Y200.;
M02;
%
The details of the file in file setting column B do not
change.
I – 140
Details of file in file setting
column A before merge.
Details of file in file setting
column B before merge.