Mitsubishi Electric MELDAS 600M Series Instruction Manual page 68

7. Restart search
position setting
column
8. Remaining distance
when restart search
is completed
9. Position when restart
search is completed
(2) Menus
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
Display item
This displays the program No. (O), sequence No. (N), block No. (B) and
the No. of block executions (P) of the program being restart searched
(including top search), or the program that is the target of the machining
time calculation. These are cleared after restart search is completed.
O This sets the program No., sequence No. and block No. targeted for
search and machining time calculation.
N
(Note) The program No. cannot be omitted for restart search.
B
P This sets the number of block executions (number of times before
restart) targeted for the search and machining time calculation.
For example, if a block in a subprogram is searched, and the subprogram
is called out several times, the block to be searched is also executed
several times. Thus, which execution block to search must be set.
To search the block executed first, or if the block is executed only once,
this item does not need to be set.
If "0" is set, the first execution block is the target.
This displays the remaining distance when the restart search is
completed.
This displays the position on the local coordinate system when the restart
search is completed.
Menu
This executes a top search based on the device,
Top
directory, program No. (O), sequence No. (N) and
search
block No. (B) in the setting columns.
This executes a restart search based on the device,
directory, program No. (O), sequence No. (N), block
Restart
search
No. (B) and the No. of block executions (P) in the
setting columns.
This calculates the machining time when the program
Time
calcul
is executed.
This cancels the machining time calculation process.
Calcul
cancel
This displays the device menu. Select the device
Device
select
storing the program to be searched from the menu.
This enters the mode for inputting the directory name.
Dir
change
Press this key to select a directory, file name or
From
program No. from a list. The selection cursor will
list
appear in the list, and a random item can be selected.
This displays the history of S, M, T and B.
When the cursor is moved and the
MSTB
history
pressed, that value becomes the current modal value
of that operation.
search engine
2. Monitor (Operation) Screens
Details
INPUT
I – 53
Details
Type
2.5.2 Executing
C top search
2.5.3 Executing
restart search
C
2.5.6 Calculating
B
the machining
time
C
2.4.1 Executing
A
an operation
search
A
(2) Operation
method
A
2.5.5 Setting the
S, M, T and B
key
A
current modal
values
Reference