Mitsubishi Electric MELDAS 600M Series Instruction Manual page 481

Error No.
PR0150
PR0151
PR0152
PR0153
PR0154
PR0155
PR0164
PR0170
PR0171
PR0172
Downloaded from ManualsNet.com
CHAPTER 4 APPENDICES
Appendix 3. Alarm Messages
Message
A tool radius compensation
No nose radius
command (G41, G42) has been
compensation
issued even though such a
command does not exist in the
specifications.
A compensation command (G40,
Radius compen in
G41, G42, G43, G44) has been
arc modal
issued in the arc modal (G02,
G03).
The intersection is not obtained
No intersection
when one block is skipped during
the processing of an interference
block with the execution of a tool
radius compensation command
(G41, G42).
An interference error has arisen
Compensation
while the tool radius
interference
compensation command (G41,
G42) was being executed.
A three-dimensional
No
compensation command was
3D-compensation
issued even though there are no
spec.
three-dimensional compensation
specifications.
A fixed cycle command has been
Fix cyc executed
issued in the radius compensation
during compen
mode.
Backward movement was
No optional
commanded even though there
backward spec.
are no backward movement
specifications.
The compensation number
No compensation
(D
number
when the radius compensation
command (G41, G42, G43) was
issued. Alternatively, the
compensation number is larger
than the number of sets in the
specifications.
G10 command has been issued
No G10 spec.
even though such a command
does not exist in the
specifications.
The address command is not
G10 L-number error
correct when the G10 command
is issued.
search engine
Details
) command was not given
IV – 39
Remedy
• Check the tool radius
compensation specification.
• Issue the linear command (G01)
or rapid traverse command
(G00) in the compensation
command block or cancel block.
(Set the modal to linear
interpolation.)
• Reconsider the program.
• Reconsider the program.
• Check the specifications.
• The radius compensation mode
is established when a fixed
cycle command is executed and
so the radius compensation
cancel command (G40) should
be issued.
• Check the specifications.
• Add the compensation number
command to the compensation
command block.
• Check the specifications.
• Check the address L-number of
the G10 command and correct
the number.