Editing Operations - Mitsubishi Electric MELDAS 600M Series Instruction Manual

4.2 Editing operations

When the program is edited, the key input data is directly written into the program display area. All data is
overwritten from the cursor position. The message "Editing" appears simultaneously with the start of
inputting. (The message disappears when the file is saved.)
If the cursor is at "%" and the
The method of saving into the memory differs according to the operation parameter "370040 Program
save type" setting.
When the program save type is 0:
If the menu key
The message "Editing" does not disappear when the
When the program save type is 1:
The file is saved in the memory each time the
The message "Editing" disappears when the
The editing operations from when the file is actually opened, or in other words, the methods of changing
the display and editing (inserting, deleting, copying, pasting, searching and replacement methods) are
explained in this section.
These editing operations are common for the machining program and MDI program.
!
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
INPUT
is pressed, the file is saved in the memory.
Save file
Caution
If there is no value after the G command, the operation will be the "G00" operation when the
program is run due to key chattering, etc., during editing.
search engine
4. Edit Screens
key is pressed, EOB (;) is added to the end of the line.
INPUT
key is pressed.
INPUT
key is pressed.
INPUT
I – 243
key is pressed.