Mitsubishi Electric MELDAS 600M Series Instruction Manual page 417

6.2 Stored stroke limit II
The boundary is set with the parameters (axis parameters "340008 soft limit (–)" and "340009 soft limit
(+)") or with the program commands. Either the inside or the outside of the set boundary is the
prohibited range. Whether the inside or outside of the range is prohibited is determined by parameter
("340011 soft limit inside"). When the inside is selected, this function is called stored stroke limit IIB.
When using program commands, entry of the tool into the prohibited range is prohibited with G22, and
entry into the prohibited range is enabled with G23.
The stored stroke limit II function can be invalidated for each axis with the parameter setting ("340007
soft limit invalid" = 1).
"340011 soft limit inside" can be set for each axis, but when used in combination, the following
operations are possible:
Downloaded from ManualsNet.com
CHAPTER 3 MAINTENANCE
6. Setting the Stored Stroke Limit
X Z
search engine
Moveable range
Moveable range
Moveable range
Moveable range
Moveable range
III – 31