Mitsubishi Electric MELDAS 600M Series Instruction Manual page 217

(2) Manual measurement status display
The display will change as shown below during manual measurement.
3.9.2 Carrying out tool radius measurement
The operating procedure of the tool radius measurement and submenu details are the same as when
measuring tool length.
(Use
T-rad. measure
Refer to "3.9.1 Carrying out tool length measurement" for details.
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
Display
On meas 1 This state is entered if a skip signal is input during manual measurement.
The "On meas 2" state is shifted to after deceleration stop is confirmed.
On meas 2 This is the state during the first retract operation.
The "On meas 3" state is shifted to after retracting the retract amount.
On meas 3 This is the state in which retract by the retract amount has completed.
If the skip after deceleration stop confirmation signal is ON, the status display will
remain the same.
The "On meas 0" state is shifted to when this state is reset.
On meas 4 This is the state during the second measurement.
If the skip signal is not input even after moving to the specified position, a
warning will appear, and the status display will remain the same.
The "On meas 0" state is shifted to when this state is reset.
On meas 5 This state is entered when the skip signal is input during the second
measurement.
The "On meas 6" state is shifted to after deceleration stop is confirmed.
On meas 6 This is the state during the second return operation.
The "On meas 0" state is shifted to after retracting the retract amount.
On meas 0 This state is entered when not in the "On meas 1" to "On meas 6" states.
instead of
search engine
3. Setup Screens
Meaning
)
T-leng measure
I – 202