Mitsubishi Electric MELDAS 600M Series Instruction Manual page 214

Screen image
1. Reference
surface height
2. Counter display
3. Manual value
setting
5. Tool offset data
(1) Display items
1. Reference surface
height
2. Counter display
3. Manual value setting
4. Guide drawing
5. Tool offset data
(Note) The TLM value counter differs according to the base common parameter "110044 TLM type
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
Display item
This displays a value for the reference surface height.
TLM value : This displays the value during measurement. (Note)
This is equivalent to the machine position when the sensor is in
contact with the workpiece.
This is the machine position where the skip signal is read in from the
sensor contact to return position.
Measurement value :
For tool length measurement type I :
For tool length measurement type II :
L meas : Z The axis selected in the operation parameters "TLM L meas axis" and
R meas : X "TLM D meas axis" is the target axis for the measurement.
This displays each command value of M (miscellaneous function
command value) and T (tool command value).
This plots the measurement location. The drawing differs depending on
the type (I/II) of tool length measurement.
"On meas" at the upper left of the drawing appears while the
measurement switch is ON.
When tool life management is invalid :
(control parameter "T-life manage valid" = 0)
This displays the tool offset data. Depending on the tool offset type (I/II),
the display details of the displayed tool offset data will differ.
∗" value.
0 : The position when the measurement switch was turned ON is displayed as 0.
1 : The display is based on the machine zero point.
search engine
3. Setup Screens
TLM value − Reference surface height
TLM value − Reference surface height + TLM reference length
I – 199
Details
4. Guide
drawing