Setting Data; Setting Numerals And Alphabetic Characters - Mitsubishi Electric MELDAS 600M Series Instruction Manual

1.4 Setting data

1.4.1 Setting numerals and alphabetic characters

(1) Operation method
The data is basically set with the following methods:
An example for setting the data on the Tool offset amnt screen is shown below.
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
1. Operating the Setting and Display Unit
1) Menu selection
2) Number selection
3) Cursor movement
4) Data key input
5) key input
INPUT
1) Menu selection
Press the menu key for the item
to be set.
Menu Tool offset
2) Number selection
If the setting item has a number
(No.), designate that number.
Menu Offset No. 11 INPUT
3) Cursor movement
If there is no number or when
moving up/down/left/right,
move the cursor with cursor
keys.
Up/down: Move with
Left/right: Move with
4) Data key input
Set data with the numeral keys or
alphabet keys, etc.
1 2 . 2
search engine
The Tool offset amnt screen appears.
The cursor appears at the Tool data.
The cursor moves to the designated number.
Tool offset amnt
Ofset No Length
11 -12345.678
12 -12345.678 -12345.678 -12345.678 -12345.678
13 -12345.678 -12345.678 -12345.678 -12345.678
14 -12345.678 -12345.678 -12345.678 -12345.678
15 -12345.678 -12345.678 -12345.678 -12345.678
16 -12345.678 -12345.678 -12345.678 -12345.678
17 -12345.678 -12345.678 -12345.678 -12345.678
The cursor moves.
Tool offset amnt
Ofset No Length
11 -12345.678 -12345.678
,
↑ ↓
12 -12345.678 -12345.678 -12345.678 -12345.678
13 -12345.678 -12345.678 -12345.678 -12345.678
← →
14 -12345.678 -12345.678 -12345.678 -12345.678
15 -12345.678 -12345.678 -12345.678 -12345.678
16 -12345.678 -12345.678 -12345.678 -12345.678
17 -12345.678 -12345.678 -12345.678 -12345.678
The data is set in the data setting area.
12. 205
0 5
I – 8
L wear Radius R wear
-12345.678 -12345.678 -12345.678
L wear Radius R wear
-12345.678 -12345.678