Mitsubishi Electric MELDAS 600M Series Instruction Manual page 5

3. Items related to preparations before use.
4. Items related to screen operation
5. Items related to programming
6. Items related to operation
Downloaded from ManualsNet.com
Always set the stored stroke limit. If not set, the axis could collide at the machine end.
Always turn the power OFF before connecting/disconnecting the input/output device
cables. The NC and input/output device could be damaged if the cable is connected
in the power ON state.
To set the tool compensation amount (tool length and tool radius) during automatic operation,
set it during single block stop. (Refer to section "3.1 Tool offset amount screen" for details.)
Pay close attention to the sequence operation when carrying out forced data setting
(forced output) in the I/F diagnosis screen.
All the data in the NC memory is erased when formatting. Be sure to use the transfer
function to transfer all the necessary data to another storage device before
formatting.
The actual data is rewritten when parameter input and tool compensation amount
change commands (40 sets or more) are issued using a G10 command during
graphic check.
To prevent the influence of data loss and data transformation over the line, always
carry out data comparison after transferring a machining program.
Do not change the machine parameters without prior consent from the machine
manufacturer.
If there is no value after the G command, the operation will be the "G00" operation
when the program is run due to key chattering, etc., during editing.
" ; " "EOB" and " % " "EOR" are symbols used for explanation.
The actual codes are: For ISO: "CR, LF", or "LF" and "%".
Programs created on the Edit screen are stored in the NC memory in a "CR, LF"
format, but programs created with external devices such as the FLD or RS-232C may
be stored in an "LF" format.
The actual codes for EIA are: "EOB (End of Block)" and "EOR (End of Record)".
Do not change the fixed cycle program without prior consent from the machine
manufacturer.
Program so the mirror image function is turned ON/OFF at the mirror image center.
The mirror image center will deviate if the function is turned ON/OFF at a position
other than the mirror image center.
Do not enter the movable range of the machine during automatic operation. Make
sure not to place hands, legs or face near the spindle during rotation.
Always carry out dry run operation before actual machining, and confirm the
machining program, tool offset amount and workpiece coordinate system offset
amount.
Do not turn OFF the NC and data server power during communication (S) between
the NC and data server. Failure to observe this could lead to NC or data server
damage.
search engine
CAUTION