Mitsubishi Electric MELDAS 600M Series Instruction Manual page 119

2.10.2 Control parameter 1 details
The system common control parameters are displayed and set on this screen.
For parameters indicated with a "∗" in the table, turn the NC power OFF after setting. The setting is
validated after the power is turned ON again.
#
310001 Initial inch ∗
310002 % rewind
310003 Edit lock B
310004 Com-var RST
310005 Com-var
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
2. Monitor (Operation) Screens
Item Setting
ON
OFF
ON
(search)
OFF
ON
OFF
ON
clear
OFF
ON
PWR-ON clear
OFF
search engine
The inch command mode the initial state when the power is
turned ON.
(The parameters, offset amount, etc., all are inch settings.)
The metric command mode the initial state when the power is
turned ON. (The input setting unit is also metric.)
During tape search, the tape is rewound and stopped when the
program is read to program end (%), and the designated block
is not found.
During tape search, the tape is not rewound when the program
is read to program end (%), and the designated block is not
found. Instead the program is stopped at that position.
Editing of the label No. 8000 to 9999 machining program is
locked.
Editing of the label No. 8000 to 9999 machining program is
enabled.
After resetting, #100 to #149 are cleared to "blank" when there
are 100 common variable sets, and #100 to #199 when there
are 200 or 300 common variable sets.
The common variables are held when reset.
When the power is turned ON, #100 to #149 are cleared to
"blank" when there are 100 common variable sets, and #100 to
#199 when there are 200 or 300 common variable sets.
The common variables are held when the power is turned ON
or OFF.
I – 104
Details