Mitsubishi Electric MELDAS 600M Series Instruction Manual page 205

(4) Restrictions
1)
2)
3)
4)
5)
6)
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
Each measurement counter display becomes blank after reflecting on the NC reset and
workpiece coordinate offset. Note that the counter is cleared to blank (measurement canceled)
by the NC reset only when the workpiece measurement screen is displayed, and only the
selected measurement counter (surface, width center or hole center) is targeted.
An error will not occur during the measurement, even if there is axis movement other than that
of the measurement target axis.
The measurement mode and measurement counter are held even when the screen changes
during measurement.
Only 1st system axes can be used as measurement target axes.
The measurement target axis is set in the operation parameters.
The axis names that can be set are those in 1st system.
The measurement values can only be set in the workpiece coordinate offset of 1st system.
An axis other than the measurement axis cannot be moved during the measurement operation
after the skip signal is input.
search engine
3. Setup Screens
I – 190