Mitsubishi Electric MELDAS 600M Series Instruction Manual page 207

3.7.2 Carrying out hole measurement
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
1)
Press the menu
Hole-M start .
2)
Turn ON the measurement
switch on the machine
operation board.
3)
Move the spindle into the hole
using manual feed and
manual handle feed.
4)
Put the tool in contact with the
inner walls of the hole.
5)
Measure points B and C in the
same way.
6)
Select the workpiece
coordinate offset in which the
measurement data will be set.
(Example)
Press the menus
Coord G54-G59 G55
select G55.
7)
Press the menu
Coord write
8)
Turn OFF the measurement
switch.
search engine
3. Setup Screens
The cursor appears at point A.
Using the and
↑
B and C.
The message "On meas" appears.
When the tool contacts the inner walls of the hole, the
skip position is displayed at the X axis and Y axis of the
point A measurement counter. The cursor moves to
point B. The cursor moves to point A when at point C.
to
The hole center is measured, and the value is set in the
.
workpiece coordinate offset G55 (coordinate system
selected in step 6).)
The measurement counter display becomes blank.
The message "On meas" disappears.
I – 192
keys, move the cursor to points
↓