Mitsubishi Electric MELDAS 600M Series Instruction Manual page 212

Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
7)
Put the spindle in contact with
the workpiece using the
manual feed or manual
handle feed.
8)
Measure points B and C in the
same way.
9)
Select the workpiece
coordinate offset in which the
measurement data will be set.
(Example)
Press the menus
Coord G54-G59 G55
select G55.
10)
Press the menu
Coord write
11)
Turn OFF the measurement
switch.
search engine
3. Setup Screens
When the spindle contacts the workpiece, the skip
position is displayed at the point A measurement
counter.
The cursor moves to point B. The cursor moves to point
A when at point C.
to
The rotation center coordinates and rotation angle are
.
measured, and the value is set in the parameters for
workpiece coordinate offset G55 (coordinates selected
in step 9)), the coordinate rotation center and
coordinate rotation angle.
The measurement counter display becomes blank.
The message "On meas" disappears.
I – 197