Mitsubishi Electric MELDAS 600M Series Instruction Manual page 507

4.9 Auxiliary axis operation warnings (AMW
AMW0001 Aux axis operation error
No.
0001
0003
0004
0005
0007
0024
0025
AMW0002 Aux axis operation error
No.
0001
0003
0060
Downloaded from ManualsNet.com
CHAPTER 4 APPENDICES
Appendix 4. Warning Messages
Details
Near-point When executing dog-type reference
dog length point, the zero point return speed is
insufficient too fast or the dog length is too
short.
Reference When executing reference point
point return return, the axis was moved in the
direction opposite of the designated direction.
illegal
External The axis interlock function is valid.
interlock
Internal An interlock was established by the
interlock servo OFF function.
Soft limit The soft limit was reached.
In absolute Reference point return was
position executed during an absolute
alarm. position alarm.
Reference
point return
not possible.
In initializing Reference point return was
absolute executing while initializing the
position. absolute position.
Reference
point return
not possible.
Details
No operation The operation mode is not
mode designated, or the operation mode
was changed during axis
movement.
Feedrate 0 The operation parameter's feedrate
setting is zero.
Or, the override is valid, and the
override value is zero.
Station No. A station No. exceeding the No. of
designation indexed divisions was designated.
illegal.
Starting not
possible.
search engine
)
• Lower the zero point return speed
or increase the dog length.
• Move the axis in the correct
direction.
• Cancel the interlock signal
• Cancel the servo OFF.
• Check the soft limit setting and
machine position
• Initialize the absolute position and
then fix the absolute position
coordinates.
• Initialize the absolute position and
then fix the absolute position
coordinates.
• Correctly designate the operation
mode.
• Set a value other than zero in the
feedrate setting or override value.
• Correctly designate the station
No.
IV – 65
Remedy
Remedy